Table of Contents
Advertisement
:BUS<n>:CLEar
Command Syntax
:BUS<n>:CLEar
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:CLEar command excludes all of the digital channels from the
selected bus definition.
This command is only valid for the MSO models.
N O T E
See Also
•
•
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see
page
786)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>"
on page 200
":BUS<n>:BITS"
on page 201
":BUS<n>:DISPlay"
on page 204
":BUS<n>:LABel"
on page 205
":BUS<n>:MASK"
on page 206
Commands by Subsystem
on page 199
5
203
Hide quick links:
Advertisement
Table of Contents
