Mtest:rmode:faction:measure - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:MTESt:RMODe:FACTion:MEASure

Command Syntax
:MTESt:RMODe:FACTion:MEASure <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :MTESt:RMODe:FACTion:MEASure command sets measuring only mask
failures on or off.
When ON, measurements and measurement statistics run only on
waveforms that contain a mask violation; passing waveforms do not affect
measurements and measurement statistics.
This mode is not available when the acquisition mode is set to Averaging.
Query Syntax
:MTESt:RMODe:FACTion:MEASure?
The :MTESt:RMODe:FACTion:MEASure? query returns the current mask
failure measure setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also
•
•
•
•
378
(see page 786)
"Introduction to :MTESt Commands"
":MTESt:RMODe:FACTion:PRINt"
":MTESt:RMODe:FACTion:SAVE"
":MTESt:RMODe:FACTion:STOP"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 360
on page 379
on page 380
on page 381