:TRIGger:M1553:AUTosetup
Command Syntax
:TRIGger:M1553:AUTosetup
The :TRIGger:M1553:AUTosetup command copies the position, volts/div,
and probe attenuation from the upper threshold channel to the lower
threshold channel, sets the upper/lower trigger levels to +/- 500 mV, turns
on serial decode, and sets the trigger mode to M1553.
See Also
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see
page
786)
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 473
":TRIGger:M1553:SOURce:UPPer"
Commands by Subsystem
on page 467
on page 571
5
567