5
Commands by Subsystem
:MARKer:X1Position
Command Syntax
:MARKer:X1Position <position> [suffix]
<position> ::= X1 cursor position in NR3 format
<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}
The :MARKer:X1Position command:
• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform
• Sets the X1 cursor position to the specified value.
Query Syntax
:MARKer:X1Position?
The :MARKer:X1Position? query returns the current X1 cursor position.
This is functionally equivalent to the obsolete :MEASure:TSTArt
command/query.
If the front-panel cursors are off, the marker position values are not defined and an error is
N O T E
generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in
the front-panel Normal mode.
Return Format
<position><NL>
<position> ::= X1 cursor position in NR3 format
See Also
•
•
•
•
•
•
298
(see
page
786)
(see
":MARKer:MODE"
"Introduction to :MARKer Commands"
":MARKer:MODE"
on page 297
":MARKer:X2Position"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:TSTArt"
on page 719
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 297).
on page 296
on page 300
on page 299
on page 301