Trigger:i2S:clock:slope - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:I2S:CLOCk:SLOPe

Command Syntax
:TRIGger:I2S:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:I2S:CLOCk:SLOPe command specifies which edge of the I2S
serial clock signal clocks in data.
• NEGative — Falling edge.
• POSitive — Rising edge.
Query Syntax
:TRIGger:I2S:CLOCk:SLOPe?
The :TRIGger:I2S:CLOCk:SLOPe? query returns the current I2S clock slope
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
•
•
530
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:I2S:ALIGnment"
":TRIGger:I2S:RWIDth"
":TRIGger:I2S:TWIDth"
":TRIGger:I2S:WSLow"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 528
on page 536
on page 542
on page 543