:MEASure:LOWer
Command Syntax
:MEASure:LOWer <voltage>
The :MEASure:LOWer command sets the lower measurement threshold
value. This value and the UPPer value represent absolute values when the
thresholds are ABSolute and percentage when the thresholds are PERCent
as defined by the :MEASure:DEFine THResholds command.
The :MEASure:LOWer command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see
instead.
Query Syntax
:MEASure:LOWer?
The :MEASure:LOWer? query returns the current lower threshold level.
Return Format
<voltage><NL>
<voltage> ::= the user-defined lower threshold in volts in NR3 format
See Also
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see
page
786)
"Introduction to :MEASure Commands"
":MEASure:THResholds"
":MEASure:UPPer"
on page 723
Obsolete and Discontinued Commands
on page 312
on page 716
7
page
316)
713