Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 4

• Chapter 8,
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 9,
• Chapter 10,
• Chapter 11,
Finally, there is a chapter that contains programming examples:
• Chapter 12,
Mixed-Signal
Because both the "analog channels only" oscilloscopes (DSO models) and
Oscilloscope the mixed- signal oscilloscopes (MSO models) have analog channels, topics
Channel
that describe analog channels refer to all oscilloscope models. Whenever a
Differences
topic describes digital channels, that information applies only to the
mixed- signal oscilloscope models.
See Also
• For more information on using the SICL, VISA, and VISA COM libraries
• For information on controller PC interface configuration, see the
• For information on oscilloscope front- panel operation, see the User's
• For detailed connectivity information, refer to the Agilent Technologies
• For the latest versions of this and other manuals, see:
4
Chapter 8, "Error Messages," starting on page 743, lists the
instrument error messages that can occur while programming the
oscilloscope.
Chapter 9, "Status Reporting," starting on page 751,
describes the oscilloscope's status registers and how to check the status
of the instrument.
Chapter
775, describes how to wait for acquisitions to complete before querying
measurement results or performing other operations with the captured
data.
Chapter
on page 785, contains additional information about oscilloscope
programming commands.
Chapter
in general, see the documentation that comes with the Agilent IO
Libraries Suite.
documentation for the interface card used (for example, the Agilent
82350A GPIB interface).
Guide.
USB/LAN/GPIB Connectivity Guide. For a printable electronic copy of
the Connectivity Guide, direct your Web browser to
and search for "Connectivity Guide".
"http://www.agilent.com/find/7000manual"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
10, "Synchronizing Acquisitions," starting on page
11, "More About Oscilloscope Commands," starting
12, "Programming Examples," starting on page 811.
"www.agilent.com"