Trigger:i2S:wslow - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:I2S:WSLow

Command Syntax
:TRIGger:I2S:WSLow <low_def>
<low_def> ::= {LEFT | RIGHt}
The :TRIGger:I2S:WSLow command selects the polarity of the word select
(WS) signal:
• LEFT— a word select (WS) state of low indicates left channel data is
• RIGHt — a word select (WS) state of low indicates right channel data is
Query Syntax
:TRIGger:I2S:WSLow?
The :TRIGger:I2S:WSLow? query returns the currently selected I2S word
select (WS) polarity.
Return Format
<low_def><NL>
<low_def> ::= {LEFT | RIGHt}
See Also •
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
active on the I2S bus, and a WS state of high indicates right channel
data is active on the bus.
active on the I2S bus, and a WS state of high indicates left channel
data is active on the bus.
"Introduction to :TRIGger Commands"
":TRIGger:I2S:ALIGnment"
":TRIGger:I2S:CLOCk:SLOPe"
":TRIGger:I2S:RWIDth"
":TRIGger:I2S:TWIDth"
on page 467
on page 528
on page 530
on page 536
on page 542
Commands by Subsystem
5
543