Measure:vstart - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:MEASure:VSTArt

Command Syntax
:MEASure:VSTArt <vstart_argument>
<vstart_argument> ::= value for vertical marker 1
The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to
the specified value corresponding to the selected source. The source can
be selected by the MARKer:X1Y1source command.
The short form of this command, VSTA, does not follow the defined Long Form to Short
N O T E
Form Truncation Rules (see
both VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.
The :MEASure:VSTArt command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:Y1Position command (see
Query Syntax
:MEASure:VSTArt?
The :MEASure:VSTArt? query returns the current value of the Y1 cursor.
Return Format
<value><NL>
<value> ::= voltage at voltage marker 1 in NR3 format
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 305
":MARKer:X1Y1source"
":MEASure:SOURce"
":MEASure:TDELta" on page 715
":MEASure:TSTArt" on page 719
Obsolete and Discontinued Commands
page 788). The normal short form, VST, would be the same for
on page 296
on page 312
on page 303
on page 304
on page 299
on page 337
7
page 303) instead.
725