Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 23

Command
:TRIGger:FLEXray:EVENt:TYPE (see
:TRIGger:FLEXray:TRIGger (see
:TRIGger:MODE (see
:WAVeform:POINts (see
:WAVeform:POINts:MODE (see
Discontinued
Most of the following commands have beed discontinued because they are
Commands
not supported by the new N5432C FlexRay triggering and decode option
(Option FLX) which replaces previous FlexRay triggering and serial decode
options.
Discontinued Command
:DISPlay:FREeze
:SBUS:BUSDoctor:ADDRess
:SBUS:BUSDoctor:BAUDrate
:SBUS:BUSDoctor:CHANnel
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
page 510)
page 516)
page 473)
page 631)
page 631)
Current Command Equivalent
none
none
none
none
Differences
The BSS (Byte Start Sequence) has been added
and the FSS (Frame Start Sequence) has been
removed.
The TIME trigger type is no longer supported.
You can now select the M1553 trigger mode.
In the RAW or MAXimum waveform points
modes, you can now specify 4,000,000 or
8,000,000 points in place of the previous
5,000,000 option.
Command syntax is the same, but the NORMal
mode returns:
•
The measurement record when
:SYSTem:PRECision is OFF.
•
The precision analysis record when
:SYSTem:PRECision is ON.
Comments
The VPT1000 (BusDoctor)
vehicle protocol tester module
is not used with the new FLX
option.
The VPT1000 (BusDoctor)
vehicle protocol tester module
is not used with the new FLX
option. You now specify the
baud rate using the
:TRIGger:FLEXray:BAUDrate
(see page
The VPT1000 (BusDoctor)
vehicle protocol tester module
is not used with the new FLX
option. You now specify bus A
or B using the
:TRIGger:FLEXray:CHANnel
(see page
1
What's New
507) command.
508) command.
23