Measure:vtop - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:MEASure:VTOP

Command Syntax
:MEASure:VTOP [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MEASure:VTOP command installs a screen measurement and starts a
waveform top value measurement.
This query is not available if the source is FFT (Fast Fourier Transform).
N O T E
Query Syntax
:MEASure:VTOP? [<source>]
The :MEASure:VTOP? query returns the vertical value at the top of the
waveform. The top value of the pulse is normally not the same as the
maximum value.
Return Format
<value><NL>
<value> ::= vertical value at the top of the waveform in NR3 format
See Also
•
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:VMAX" on page 349
":MEASure:VAMPlitude"
":MEASure:VBASe" on page 348
on page 312
on page 337
on page 346
Commands by Subsystem
5
355