Pod<N>:Display - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:POD<n>:DISPlay
Command Syntax
:POD<n>:DISPlay <display>
<display> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to the command and
POD1 ::= D0-D7
POD2 ::= D8-D15
The :POD<n>:DISPlay command turns displaying of the specified group of
channels on or off.
This command is only valid for the MSO models.
N O T E
Query Syntax
:POD<n>:DISPlay?
The :POD<n>:DISPlay? query returns the current display setting of the
specified group of channels.
Return Format
<display><NL>
<display> ::= {0 | 1}
See Also •
•
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
defines the group of channels that are affected by the command.
"Introduction to :POD<n> Commands"
":DIGital<n>:DISPlay"
":CHANnel<n>:DISPlay"
":VIEW" on page 180
":BLANk" on page 148
":STATus" on page 177
on page 392
on page 239
on page 222
Commands by Subsystem
5
393