Table of Contents
Advertisement
5
Commands by Subsystem
:BUS<n>:DISPlay
Command Syntax
:BUS<n>:DISplay <value>
<value> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:DISPlay command enables or disables the view of the selected
bus.
This command is only valid for the MSO models.
N O T E
Query Syntax
:BUS<n>:DISPlay?
The :BUS<n>:DISPlay? query returns the display value of the selected bus.
Return Format
<value><NL>
<value> ::= {0 | 1}
See Also
•
•
•
•
•
•
204
(see
page
786)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>"
on page 200
":BUS<n>:BITS"
on page 201
":BUS<n>:CLEar"
on page 203
":BUS<n>:LABel"
on page 205
":BUS<n>:MASK"
on page 206
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 199
Hide quick links:
Advertisement
Table of Contents
