Digital<N>:Label - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem
:DIGital<n>:LABel
Command Syntax
:DIGital<n>:LABel <string>
<string> ::= any series of 10 or less characters as quoted ASCII string.
<n> ::= An integer, 0,..,15, is attached as a suffix to the command and
defines the logic channel that is affected by the command.
The :DIGital<n>:LABel command sets the channel label to the string that
follows. Setting a label for a channel also adds the name to the label list
in non- volatile memory (replacing the oldest label in the list).
This command is only valid for the MSO models.
N O T E
Label strings are 10 characters or less, and may contain any commonly used ASCII
N O T E
characters. Labels with more than 10 characters are truncated to 10 characters.
Query Syntax
:DIGital<n>:LABel?
The :DIGital<n>:LABel? query returns the name of the specified channel.
Return Format
<label string><NL>
<label string> ::= any series of 10 or less characters as a quoted
See Also •
•
•
•
240
(see page 786)
ASCII string.
"Introduction to :DIGital<n> Commands"
":CHANnel<n>:LABel"
":DISPlay:LABList" on page 250
":BUS<n>:LABel" on page 205
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 237
on page 225