Channel<N>:Scale - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem
:CHANnel<n>:SCALe
Command Syntax
:CHANnel<n>:SCALe <scale>[<suffix>]
<scale> ::= vertical units per division in NR3 format
<suffix> ::= {V | mV}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :CHANnel<n>:SCALe command sets the vertical scale, or units per
division, of the selected channel. When using 1:1 probe attenuation, legal
values for the scale are shown in the following table.
Table 61 Vertical Scale Values with 1:1 Probe Attenuation
Models
DSO/MSO701xA/B
DSO/MSO703xA/B
DSO/MSO705xA/B
DSO/MSO7104A/B
If the probe attenuation is changed, the scale value is multiplied by the
probe's attenuation factor.
Query Syntax
:CHANnel<n>:SCALe?
The :CHANnel<n>:SCALe? query returns the current scale setting for the
specified channel.
Return Format
<scale value><NL>
<scale value> ::= vertical units per division in NR3 format
See Also
•
•
•
234
(see page 786)
"Introduction to :CHANnel<n> Commands"
":CHANnel<n>:RANGe"
":CHANnel<n>:PROBe"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
Input Impedance
1 MΩ
2 mV to 5 V
2 mV to 5 V
2 mV to 5 V
2 mV to 5 V
on page 233
on page 227
50 Ω
2 mV to 5 V
2 mV to 5 V
2 mV to 5 V
2 mV to 1 V
on page 218