Trigger:flexray:frame:ccbase - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:FLEXray:FRAMe:CCBase

Command Syntax
:TRIGger:FLEXray:FRAMe:CCBase <cycle_count_base>
<cycle_count_base> ::= integer from 0-63
The :TRIGger:FLEXray:FRAMe:CCBase command sets the base of the
FlexRay cycle count (in the frame header) to trigger on. The cycle count
base setting is only valid when the FlexRay trigger mode is set to FRAME.
This command is only valid when the FLEXray triggering and serial decode option (Option
N O T E
FLX) has been licensed.
Query Syntax
:TRIGger:FLEXray:FRAMe:CCBase?
The :TRIGger:FLEXray:FRAMe:CCBase? query returns the current cycle
count base setting for the FlexRay frame trigger setup.
Return Format
<cycle_count_base><NL>
<cycle_count_base> ::= integer from 0-63
See Also •
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:FLEXray:TRIGger"
Commands by Subsystem
on page 467
on page 516
5
511