Trigger:iic:pattern:data - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:IIC:PATTern:DATA

Command Syntax
:TRIGger:IIC:PATTern:DATA <value>
<value> ::= integer or <string>
<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F}
The :TRIGger:IIC:PATTern:DATA command sets IIC data. The data value
can range from 0x00 to 0x0FF (hexadecimal). Use the don't care data
pattern (- 1 or 0xFFFFFFFF) to ignore the data value.
Query Syntax
:TRIGger:IIC:PATTern:DATA?
The :TRIGger:IIC:PATTern:DATA? query returns the current pattern for IIC
data.
Return Format
<value><NL>
See Also •
•
•
•
546
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:IIC:PATTern:ADDRess"
":TRIGger:IIC:PATTern:DATa2"
":TRIGger:IIC:TRIGger[:TYPE]"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 545
on page 547
on page 551