Digital<N>:Position - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:DIGital<n>:POSition
Command Syntax
:DIGital<n>:POSition <position>
<position> ::= integer in NR1 format.
<n> ::= An integer, 0, 1,..,15, is attached as a suffix to the command
Channel Size
Large
Medium
Small
The :DIGital<n>:POSition command sets the position of the specified
channel.
This command is only valid for the MSO models.
N O T E
Query Syntax
:DIGital<n>:POSition?
The :DIGital<n>:POSition? query returns the position of the specified
channel.
Return Format
<position><NL>
<position> ::= integer in NR1 format.
See Also
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
and defines the logic channel that is affected by the command.
Position
0-7
0-15
0-31
"Introduction to :DIGital<n> Commands"
Commands by Subsystem
Top Bottom
7 0
15 0
31 0
on page 237
5
241