Marker:x2Position - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:MARKer:X2Position

Command Syntax
:MARKer:X2Position <position> [suffix]
<position> ::= X2 cursor position in NR3 format
<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}
The :MARKer:X2Position command:
• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform
• Sets the X2 cursor position to the specified value.
Query Syntax
:MARKer:X2Position?
The :MARKer:X2Position? query returns current X2 cursor position. This is
functionally equivalent to the obsolete :MEASure:TSTOp command/query.
If the front-panel cursors are off, the marker position values are not defined and an error is
N O T E
generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in
the front-panel Normal mode.
Return Format
<position><NL>
<position> ::= X2 cursor position in NR3 format
See Also
•
•
•
•
•
300
(see page 786)
(see ":MARKer:MODE"
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 297
":MARKer:X1Position"
":MARKer:X2Y2source"
":MEASure:TSTOp" on page 720
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 297).
on page 296
on page 298
on page 301