Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 168

5
Commands by Subsystem
Table 53 Operation Status Event Register (continued)
Bit
3
2-0
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also •
•
•
•
•
•
•
•
•
•
•
•
•
168
Name Description
Run Running
--- ---
"Introduction to Root (:) Commands"
":CHANnel<n>:PROTection"
":EXTernal:PROTection"
":OPEE (Operation Status Enable Register)"
":OPERegister:CONDition (Operation Status Condition Register)"
page 165
":OVLenable (Overload Event Enable Register)"
":OVLRegister (Overload Event Register)"
"*STB (Read Status Byte)"
"*SRE (Service Request Enable)"
":HWERegister[:EVENt] (Hardware Event Event Register)"
":HWEenable (Hardware Event Enable Register)"
":MTERegister[:EVENt] (Mask Test Event Event Register)"
":MTEenable (Mask Test Event Enable Register)"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
When Set (1 = High = True), Indicates:
The oscilloscope has gone from a stop state to
a single or running state.
(Not used.)
on page 141
on page 232
on page 261
on page 171
on page 134
on page 132
on page 163
on page 169
on page 156
on page 152
on page 161
on page 159
on