Subaru Legacy 2005 Service Manual page 1846

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1
CHECK ANY OTHER DTC ON DISPLAY.
2
CHECK REAR OXYGEN SENSOR DATA.
1) Warm-up the engine until engine coolant
temperature is above 70°C (158°F), and lower
the engine speed rapidly from 5,000 rpm.
2) Read the data of rear oxygen sensor signal
using Subaru Select Monitor or general scan
tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedure, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H6DO)(diag)-26, Subaru Select Moni-
tor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
3
CHECK HARNESS BETWEEN ECM AND
REAR OXYGEN SENSOR CONNECTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ECM and
rear oxygen sensor.
3) Measure the resistance of harness
between ECM and rear oxygen sensor con-
nector.
Connector & terminal
(B137) No. 24 — (E61) No. 3:
(B136) No. 35 — (E61) No. 4:
4
CHECK HARNESS BETWEEN REAR OXY-
GEN SENSOR AND ECM CONNECTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from rear oxygen
sensor.
3) Turn the ignition switch to ON.
4) Measure the voltage between rear oxygen
sensor harness connector and chassis ground.
Connector & terminal
(E61) No. 3 (+) — Chassis ground (
Check
Is any other DTC displayed?
Is the voltage more than 250
mV?
Is the resistance more than 3
Ω?
Is the voltage 0.2 — 0.5 V?
):
EN(H6DO)(diag)-150
Yes
Check DTC using
Go to step 2.
the List of Diag-
nostic Trouble
Code (DTC). <Ref.
to
EN(H6DO)(diag)-
66, List of Diag-
nostic Trouble
Code (DTC).>
NOTE:
In this case, it is
not necessary to
inspect
DTC
P0138.
Go to step 5.
Go to step 3.
Repair the open
Go to step 4.
circuit of harness
between ECM and
rear oxygen sen-
sor connector.
Replace the rear
Repair the har-
oxygen sensor.
ness and connec-
<Ref. to
tor.
FU(H6DO)-32,
NOTE:
Rear Oxygen Sen-
In this case, repair
sor.>
the following:
• Open circuit of
harness between
rear oxygen sen-
sor and ECM con-
nector
• Poor contact in
rear oxygen sen-
sor connector
• Poor contact in
ECM connector
No

Advertisement

Table of Contents
loading

Table of Contents