Chrysler 2005 Crossfire SRT6 Service Manual page 2009

ZH
(P0120) ELECTRONIC THROTTLE CONTROL MOTOR PERFORMANCE (CONTINUED)
18.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE 5-VOLT SUPPLY CIRCUIT
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the 5-Volt Supply circuit.
Is the resistance above 100 kohms?
Yes >> Go To 19
No >> Repair the 5-Volt Supply circuit for a short to ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
19.
MEASURE RESISTANCE BETWEEN THE 5-VOLT SUPPLY CIRCUIT AND SENSOR GROUND CIRCUITS
With the ignition off.
Measure the resistance between the 5-Volt Supply circuit and all Sen-
sor Ground circuits in the PCM C3 harness connector.
Is the resistance above 100 kohms for all measurements?
Yes >> Go To 20
No >> Repair the 5-Volt Supply circuit for a short to the Sensor
Ground circuit that measured below 100 kohms.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 85