Honda 2004 Odyssey Service Manual page 1673

Rear Heater-A/C
Rear Blower Unit Removal and
Installation
1. Remove the rear side trim panel of the right side
(see page 20-60).
2. Disconnect the connectors (A) from the rear blower
motor and the rear blower resistor, then remove
the self-tapping screws, the mounting bolts and the
rear blower unit (B).
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
3. Install the unit in the reverse order of removal.
Make sure that there is no air leakage.
21-142 21-142
B
A
Rear Blower Unit Component
Replacement
1. Remove the self-tapping screws and the rear
blower motor (A). Remove the self-tapping screws
and the rear blower resistor (B).
A
2. Install the motor and the resistor in the reverse
order of removal.
B