Tftp Configuration Example - Huawei Quidway S3900 Series Operation Manual

Operation Manual – FTP and TFTP
Quidway S3900 Series Ethernet Switches-Release 1510
Note:
The specified interface must be an existing one, and otherwise a prompt appears to
show the configuration fails.
The value of argument ip-address must be an IP address on the device where the
configuration is performed, and otherwise a prompt appears to show the
configuration fails.
The latest connection setting is prior to the fixed setting. That is, if you configure the
source IP address or source interface be used when the TFTP client connect with
an TFTP server for the next time, and the IP address or interface is different from
that set by the source-interface or ftp-server source-ip command, the former will
be used for the next connection.
You may specify only one source interface or source IP address for the TFTP client
at one time. That is, only one of the commands source-interface and ftp-server
source-ip can be effective at one time. If both commands are configured, the one
configured later will overwrite the original one.

1.2.3 TFTP Configuration Example

I. Network requirements
A switch operates as a TFTP client and a PC as the TFTP server.
The TFTP work directory is configured on the TFTP server.
The IP address of a VLAN interface on the switch is 1.1.1.1. The port through
which the switch connects with the PC belongs to the VLAN. The IP address of the
PC is 1.1.1.2.
The application named switch.bin is stored on the PC. Download it to the switch
through TFTP, and upload the configuration file named vrpcfg.cfg to the work directory
on the PC to backup the configuration file.
II. Network diagram
Switch Switch Switch
Figure 1-5 Network diagram for TFTP configurations
Network Network
Huawei Technologies Proprietary
1-17
Chapter 1 FTP and TFTP Configuration
PC PC