Huawei Quidway S3900 Series Operation Manual page 279

Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510
II. Network diagram
Switch C Switch C
Figure 1-7 Network diagram for implementing MSTP
Note:
The "Permit:" shown in Figure 1-7 means the corresponding link permits packets of
specific VLANs.
III. Configuration procedure
Configure Switch A.
# Enter MST region view.
<Quidway> system-view
[Quidway] stp region-configuration
# Configure the MST region.
[Quidway-mst-region] region-name example
[Quidway-mst-region] instance 1 vlan 10
[Quidway-mst-region] instance 3 vlan 30
[Quidway-mst-region] instance 4 vlan 40
[Quidway-mst-region] revision-level 0
# Activate the settings of the MST region.
[Quidway-mst-region] active region-configuration
# Specify Switch A as the root bridge of spanning tree instance 1.
[Quidway] stp instance 1 root primary
Configure Switch B.
# Enter MST region view.
<Quidway> system-view
[Quidway] stp region-configuration
Permit :all VLAN Permit :all VLAN
Switch A Switch A
Permit : Permit :
VLAN 10, 20 VLAN 10, 20
Permit : Permit :
VLAN 10, 20 VLAN 10, 20
Permit :VLAN 20, 40 Permit :VLAN 20, 40
Huawei Technologies Proprietary
Switch B Switch B
Permit : Permit :
VLAN 20, 30 VLAN 20, 30
Permit : Permit :
VLAN 20, 30 VLAN 20, 30
1-45
Chapter 1 MSTP Configuration
Switch D Switch D