Operation Manual – ARP
Quidway S3900 Series Ethernet Switches-Release 1510
Caution:
Static ARP mapping entries are valid as long as the Ethernet switch operates. But
the following operations result in ARP entries being removed: changing/removing
a VLAN interface, removing a VLAN, or removing a port from a VLAN.
As for the arp static command, the value of the vlan-id argument must be the ID of
an existing VLAN, and the port identified by the interface-type and
interface-number arguments must belong to the VLAN.
Currently, the system does not support static ARP mapping entry at aggregation
port.
1.2.2 Configuring the ARP Aging Timer for Dynamic ARP Entries
The ARP aging timer applies to all dynamic ARP mapping entries.
Table 1-6 Configure the ARP aging timer for dynamic ARP entries
Operation
Enter system view
Configure the ARP
aging timer
1.2.3 Enabling the ARP Entry Checking Function
When multiple hosts share one multicast MAC address, you can specify whether or
not to create multicast MAC address ARP entries for MAC addresses learned by
performing the operations listed in Table 1-7.
Table 1-7 Enable the ARP entry checking function
Enter system view
Enable
checking function (that is,
disable the switch from
creating
address ARP entries for
MAC addresses learned)
system-view
arp timer aging aging-time
Operation
the
ARP
entry
multicast
MAC
Huawei Technologies Proprietary
Command
Command
system-view
arp check enable
1-7
Chapter 1 ARP Configuration
Description
—
Optional
By default, the ARP aging
timer is set to 20 minutes.
Description
—
Optional
By default, the ARP
entry
function is enabled.
checking