Management Device Configuration; Management Device Configuration Tasks - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510

1.2 Management Device Configuration

1.2.1 Management Device Configuration Tasks

Table 1-2 Management device configuration tasks
Operation
Enable
globally
specific ports
Configure
NDP-related
parameters
Enable
globally
specific ports
Configure
NTDP-related
parameters
Enable the cluster
function
Configure
parameters
Configure
interaction for the
cluster
Configure
interface for the
cluster
Note:
To protect the unused sockets against malicious attacks and improve the switch
security, S3900 series Ethernet switches provide the following function:
When the cluster function is enabled, socket UDP 40000 used by the cluster is
enabled;
When the cluster function is disabled, socket UDP 40000 is disabled at the same
time.
This function is implemented on the command switch in the following scenarios:
Use the build command or the auto-build command to create a cluster and enable
socket UDP 40000 used by the cluster at the same time.
Use the undo build command or the undo cluster enable command to remove a
cluster and disable socket UDP 40000 at the same time.
Description
NDP
and for Required
Required
NTDP
and for Required
Required
Required
cluster
Required
Required
NM
Optional
Huawei Technologies Proprietary
Section 1.2.2 Enabling NDP
Globally and for Specific Ports
Section 1.2.3
NDP-related Parameters
Section 1.2.4 Enabling NTDP
Globally and for Specific Ports
Section 1.2.5
NTDP-related Parameters
Section 1.2.6
Cluster Function
Section 1.2.7
Cluster Parameters
Section 1.2.8
Interaction for the Cluster
Section 1.2.9 Configuring NM
Interface for the Cluster
1-7
Chapter 1 Cluster
Related section
Configuring
Configuring
Enabling the
Configuring
Configuring