Basic Ospf Configuration - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
OSPF network adjustment
and optimization
Displaying and maintaining OSPF configuration

4.3 Basic OSPF Configuration

Before you can configure other OSPF features, you must first enable OSPF and
specify the interface and area ID.
4.3.1 Configuration Prerequisites
Before configuring OSPF, perform the following tasks:
Configuring the link layer protocol
Configuring the network layer addresses of interfaces so that the adjacent nodes
are reachable to each other at the network layer
4.3.2 Basic OSPF Configuration
Basic OSPF configuration includes:
Configuring router ID
To ensure stable OSPF operation, you should determine the division of router IDs and
manually configure them when implementing network planning. When you configure
router IDs manually, make sure each router ID is uniquely used by one router in the
Configuration task
Configuring OSPF timers
Configuring
transmission delay
Configuring
calculation interval
Disabling OSPF packet
transmission
interface
Configuring
authentication
Configuring to fill the MTU
field when an interface
transmits DD packets
Enabling OSPF logging
Configuring
network
system (NMS)
Huawei Technologies Proprietary
4-10
Chapter 4 OSPF Configuration
Description
Optional
the LSA
Optional
the SPF
Optional
on an Optional
OSPF
Optional
Optional
Optional
OSPF
management Optional
—
Related
section
4.7.2
4.7.3
4.7.4
4.7.5
4.7.6
4.7.7
4.7.8
4.7.9
4.8