Setting Ospf Route Priority; Configuring The Maximum Number Of Ospf Equal-Cost Routes - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Configure the cost for sending
packets on an OSPF interface

4.6.5 Setting OSPF Route Priority

Since multiple dynamic routing protocols may be running on one router, the problem
of route sharing and selection between various routing protocols arises. The system
sets a priority for each routing protocol (which you can change manually), and when
more than one route to the same destination is discovered by different protocols, the
route with the highest priority will take preference over other routes.
Table 4-11 Set OSPF route priority
Enter system view
Enter OSPF view
Set OSPF route priority

4.6.6 Configuring the Maximum Number of OSPF Equal-Cost Routes

Table 4-12 Configure the maximum number of OSPF equal-cost routes
Enter system view
Enter OSPF view
Configure the maximum number
of OSPF equal-cost routes
Operation
Operation
system-view
ospf
[ router-id router-id ] ]
preference [ ase ] value
Operation
Huawei Technologies Proprietary
Command
ospf cost value
Command
[ process-id
Command
system-view
ospf [ process-id
[ router-id router-id ] ]
multi-path-number value
4-18
Chapter 4 OSPF Configuration
Description
Optional
By default,
calculates the cost for
sending packets on an
interface according to
the current baud rate
on the interface. For a
VLAN interface on the
switch, this value is
fixed at 10.
Description
—
Required
Optional
By default, the OSPF
route priority is 10 and the
priority of OSPF ASE is
150.
Description
—
Required
Optional
OSPF