Configuring Cluster Parameters - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Cluster
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Enable the cluster
function globally

1.2.7 Configuring Cluster Parameters

I. Configuring cluster parameters manually
Table 1-8 Configure cluster parameters manually
Operation
Enter system view
Specify
management
VLAN
Enter cluster view
Configure
address pool for
the cluster
Build a cluster
Configure
multicast
address
cluster
Set the interval for
the management
device
multicast packets
Configure
holdtime
switch
Set the interval to
send
packets
Quit cluster view
cluster enable
system-view
the
management-vlan vlan-id
cluster
an IP ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
build name
a
MAC
cluster-mac H-H-H
for the
cluster-mac
to send time-interval
the
for a holdtime seconds
handshake timer interval
quit
Huawei Technologies Proprietary
Command
Command
syn-interval
1-10
Chapter 1 Cluster
Description
Optional
By default, the cluster function
is enabled
Description
—
This is to specify
management VLAN on the
switch
—
Required
Optional
The name argument is the
name to be assigned to the
cluster.
Optional
By default, the multicast MAC
address is 0180-C200-000A
Optional
By default, the management
device sends a multicast
packet every minute.
Optional
By default, the holdtime is 60
seconds
Optional
By default, the interval to send
handshake packets is 10
seconds
—
the