Displaying And Maintaining Vrrp; Vrrp Configuration Example; Single-Vrrp Backup Group Configuration - Huawei Quidway S3900 Series Operation Manual

Operation Manual – VRRP
Quidway S3900 Series Ethernet Switches-Release 1510
Table 1-6 Configure the auto detect function for VRRP
Operation
Enter system view
Enter
interface view
Enable the auto
detect function for
VRRP
Note:
A detecting group can be used to detect up to eight Layer 3 interfaces.

1.3 Displaying and Maintaining VRRP

After the above configurations, you can execute the display command in any view to
view VRRP configuration and verify the configuration effect. And you can execute the
reset command in user view to clear the VRRP statistics.
Table 1-7 Display and Maintain VRRP
Operation
Display
state
and
information
Clear
statistics

1.4 VRRP Configuration Example

1.4.1 Single-VRRP Backup Group Configuration

I. Network requirements
Host A uses the VRRP virtual router comprising switch A and switch B as its default
gateway to visit host B on the Internet.
The information about the VRRP backup group is as follows:
VRRP backup group ID: 1
system-view
VLAN interface
vlan-id
Vrrp vrid
track
group-number
value-reduced ]
VRRP display vrrp [ interface
information vlan-interface
statistics statistics [ vlan-interface
vlan-id ] ] [ virtual-router-id ]
reset
VRRP
[ vlan-interface vlan-id ]
[ virtual-router-id ]
Huawei Technologies Proprietary
Command
vlan-interface
virtual-router-id
detect-group
[ reduced
Command
vlan-id |
vrrp statistics
1-10
Chapter 1 VRRP Configuration
Description
—
—
Required
Description
This command can
executed in any view.
Execute this command in user
view.
be