Auto Detect Implementation In Static Routing; Chapter 2 Auto Detect Implementation; Configuring The Auto Detect Function For A Static Route - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Auto Detect
Quidway S3900 Series Ethernet Switches-Release 1510

Chapter 2 Auto Detect Implementation

2.1 Introduction
The results of auto detect operations (reachable or unreachable) can be used to
trigger other functions, such as:
Static routing
Virtual router redundancy protocol (VRRP)
Interface backup
Packet redirection
You can utilize a single detecting group simultaneously in multiple implementations
mentioned above.
Note:
Refer to the Routing Protocol chapter of this manual for information about static
routing.
Refer to the VRRP chapter of this manual for information about VRRP.

2.2 Auto Detect Implementation in Static Routing

By binding a detecting group to a static route, you can control the validity of a static
route according to auto detect results as follows:
Enable the static route when the result of the detecting group is reachable.
Disable the static route when the result of the detecting group is unreachable.

2.2.1 Configuring the Auto Detect Function for a Static Route

Note:
You need to create the detecting group before performing the following operations.
Table 2-1 Configure the auto detect function for a static route
Operation
Enter system view
Command
system-view
Huawei Technologies Proprietary
2-1
Chapter 2 Auto Detect Implementation
Description
—