Huawei Quidway S3900 Series Operation Manual page 469

Operation Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Configure
maximum number
of
on-line users for
specified ports
Configure
maximum
times
request packets
Configure
timers
Trigger
quiet-period timer
Note:
As for the dot1x max-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can
also use this command in port view. In this case, this command applies to the
current port only and the interface-list argument is not needed.
As for the configuration of 802.1x timers, the default values are recommended.
Command
In system view:
dot1x
the
user-number
interface-list ]
concurrent
In port view:
dot1x
user-number
the
retry
dot1x retry max-retry-value
to send
dot1x
{
handshake-period-value
quiet-period
quiet-period-value
802.1x tx-period tx-period-value |
supp-timeout
supp-timeout-value
server-timeout
server-timeout-value
ver-period
ver-period-value }
the
dot1x quiet-period
Huawei Technologies Proprietary
max-user
[ interface
max-user
timer
handshake-period
|
|
|
|
1-15
Chapter 1 802.1x Configuration
Description
Optional
By default, up to
concurrent on-line users are
allowed on each port.
Optional
By default, the maximum retry
times to send a request
packet is 2. That is, the
authenticator system sends a
request packet to a supplicant
system for up to two times by
default.
Optional
The default values of 802.1x
timers are as follows:
handshake-period-value:
15 seconds
quiet-period-value:
seconds
tx-period-value:
seconds
supp-timeout-value:
seconds
server-timeout-value: 100
seconds
ver-period-value:
seconds
Optional
By default, a quiet-period
timer is disabled.
256
60
30
30
30