Ethernet Port Configuration Example - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Table 1-15 Display basic port configuration
Operation
Display
configuration
information
Display
about
optical port
Display
enable/disable status
of port
detection
Display
information about port
configuration
Display the hybrid or
trunk ports
Display
information about a
specified unit
Clear port statistics

1.3 Ethernet Port Configuration Example

I. Network requirements
Switch A and Switch B are connected to each other through two trunk port
(Ethernet1/0/1).
Configure the default VLAN ID of both Ethernet1/0/1 to 100.
Allow the packets of VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 to pass
both Ethernet1/0/1.
port display
[ interface-type | interface-type
interface-number ]
display
information
transceiver-information
a specified
interface
interface-number
the
display loopback-detection
loopback
display
brief
[
interface-number ] [ | { begin |
include | exclude } string ]
display port { hybrid | trunk }
port
display unit unit-id interface
reset
[ interface-type | interface-type
interface-number ]
Huawei Technologies Proprietary
Chapter 1 Port Basic Configuration
Command
interface
interface-type
brief interface
interface-type
counters interface
1-12
Remarks
You can execute the
display commands in
any view.
You can execute the
reset command in user
view.
After 802.1x is enabled
on a port, clearing the
statistics on the port will
not work.