Huawei Quidway S3900 Series Operation Manual page 74

Operation Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
Workstation Workstation
Server Server
Figure 3-6 Network diagram for Telnet connection establishment
4) Launch Telnet on your PC, with the IP address of the management VLAN interface
of the switch as the parameter, as shown in Figure 3-7.
Figure 3-7 Launch Telnet
5) Enter the password when the Telnet window displays "Login authentication" and
prompts for login password. The CLI prompt (such as <Quidway>) appears if the
password is correct. If all VTY user interfaces of the switch are in use, you will fail
to establish the connection and receive the message that says "All user interfaces
are used, please try later!". A Quidway series Ethernet switch can accommodate
up to five Telnet connections at same time.
6) After successfully Telneting to a switch, you can configure the switch or display the
information about the switch by executing corresponding commands. You can
also type ? at any time for help. Refer to the following chapters for the information
about the commands.
Ethernet Ethernet
PC w ith Telnet PC w ith Telnet
Workstation Workstation
running on it running on it
(used to configure (used to configure
the switch) the switch)
Huawei Technologies Proprietary
Chapter 3 Logging in through Telnet
Ethernet port Ethernet port
3-17