Configuring A Static Lacp Aggregation Group - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Link Aggregation
Quidway S3900 Series Ethernet Switches-Release 1510
1) When creating an aggregation group:
If the aggregation group you are creating already exists but contains no port, its
type will change to the type you set.
If the aggregation group you are creating already exists and contains ports, the
possible type changes may be: changing from dynamic or static to manual, and
changing from dynamic to static; and no other kinds of type change can occur.
When you change a dynamic/static group to a manual group, the system will
automatically disable LACP on the member ports. When you change a
dynamic/static group to a manual group, the system will remain the member ports
LACP-enabled.
2) When a manual or static aggregation group contains only one port, you cannot
remove the port unless you remove the whole aggregation group.

1.2.2 Configuring a Static LACP Aggregation Group

You can create a static LACP aggregation group, or remove an existing static
aggregation group (after that, the system will re-aggregate the original member ports in
the group to form one or more dynamic aggregation groups.).
You can manually add/remove a port to/from a static aggregation group, and a port can
only be manually added/removed to/from a static aggregation group.
Note:
When you add an LACP-enabled port to a manual aggregation group, the system will
automatically disable LACP on the port. Similarly, when you add an LACP-disabled port
to a static aggregation group, the system will automatically enable LACP on the port.
Table 1-2 Configure a static LACP aggregation group
Operation
Enter system view
Create
aggregation group
Configure
description for the
aggregation group
Enter
port view
Command
system-view
link-aggregation
a static
group agg-id
static
a link-aggregation
group
description agg-name
interface
Ethernet
interface-type
interface-number
Huawei Technologies Proprietary
Chapter 1 Link Aggregation Configuration
—
mode Required
Optional
agg-id
By default, an aggregation group
has no description.
—
1-9
Description