Vlan-Vpn Configuration; Configuration Prerequisites; Configuration Procedure - Huawei Quidway S3900 Series Operation Manual

Operation Manual – VLAN VPN
Quidway S3900 Series Ethernet Switches-Release 1510
IPX
IS-IS
LACP
802.1x

1.2 VLAN-VPN Configuration

1.2.1 Configuration Prerequisites

GARP VLAN registration protocol (GVRP), GARP multicast registration protocol
(GMRP), intelligent resilient framework (IRF), neighbor topology discovery
protocol (NTDP), spanning tree protocol (STP) and 802.1x protocol are disabled
on the port.
The port is must an access port.
Caution:
If any of the protocols among GVRP, GMRP, IRF, NTDP, STP and 802.1x is
enabled for a port, you can not enable the VLAN-VPN function for the port.
By default, STP and NTDP are enabled on a device. You can disable these two
protocols using the stp disable and undo ntdp enable commands.
If there is a port enabled with fabric function on a device, you cannot enable
VLAN-VPAN function for this port or for any other port on this device.

1.2.2 Configuration procedure

Table 1-2 Configure the VLAN-VPN function for a port
Operation
Enter system view
Enter Ethernet port
view
Enable
VLAN-VPN
function on the port
Protocol type
Command
system-view
interface
interface-number
the
vlan-vpn enable
Huawei Technologies Proprietary
1-3
Chapter 1 VLAN-VPN Configuration
0x8137
0x8000
0x8809
0x888E
—
interface-type
—
Required
By default, the VLAN-VPN
function is disabled on a port.
Value
Description