Controlling Telnet Users; Chapter 8 User Control; Controlling Telnet Users By Source Ip Addresses - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
8.1 Introduction
A switch provides ways to control different types of login users, as listed in Table 8-1.
Table 8-1 Ways to control different types of login users
Login
mode
Telnet
SNMP
WEB

8.2 Controlling Telnet Users

8.2.1 Prerequisites
The controlling policy against Telnet users is determined, including the source and
destination IP addresses and source MAC addresses to be controlled and the
controlling actions (permitting or denying).

8.2.2 Controlling Telnet Users by Source IP Addresses

Controlling Telnet users by source IP addresses is achieved by applying basic ACLs,
which are numbered from 2000 to 2999.

Chapter 8 User Control

Control
Implementation
method
By source IP Through
address ACL
By source and
Through
destination IP
advanced ACL
address
By source Through Layer 2
MAC address ACL
By source IP Through
addresses ACL
By source IP Through
addresses ACL
Disconnect By
Web users by commands
force CLI
Huawei Technologies Proprietary
8-1
Related section
basic Section 8.2.2 "Controlling Telnet
Users by Source IP Addresses".
Section 8.2.3 "Controlling Telnet
Users by Source and Destination
IP Addresses".
Section 8.2.4 "Controlling Telnet
Users
Addresses"
Section 8.3 "Controlling Network
basic
Management Users by Source IP
Addresses".
basic Section 8.4
Users by Source IP Address".
executing
Section 8.4.3 "Disconnecting a
in
Web User by Force".
Chapter 8 User Control
by Source MAC
"Controlling Web