Snmp Configuration Example - Huawei Quidway S3900 Series Operation Manual

Operation Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510
Display Trap list information
Display
community name
Display the currently configured MIB
view

1.6 SNMP Configuration Example

1.6.1 SNMP Configuration Example
I. Network requirements
An NMS and Switch A are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
Perform the following configuration on Switch A: setting the community name and
access authority, administrator ID, contact and switch location, and enabling the
switch to sent trap packet.
II. Network diagram
10.10.10.1 10.10.10.1
NM S NM S
Figure 1-2
III. Network procedure
# Set the community name, group name and user.
<Quidway> system-view
[Quidway] snmp-agent
[Quidway] snmp-agent sys-info version all
[Quidway] snmp-agent community write public
Operation
the currently configured
Ethernet Ethernet
Network diagram for SNMP
Huawei Technologies Proprietary
Chapter 1 SNMP Configuration
Command
display snmp-agent
trap-list
display snmp-agent
community [ read |
write ]
display snmp-agent
mib-view [ exclude |
include |
view-name ]
10.10.10 .2 10.10.10 .2
1-9
Description
viewname