Rip Route Control - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Enable the interface to
receive
packets
Enable the interface to
send
packets
Run
interface
III. Specifying the RIP version on an interface
Table 3-4 Specify the RIP version on an interface
Operation
Enter system view
Enter interface view
Specify RIP version on
the interface

3.4 RIP Route Control

In actual implementation, it may be needed to control RIP routing information more
accurately to accommodate complex network environments. By performing the
configuration described in the following sections, you can:
Control route selection by adjusting additional routing metrics on interfaces
running RIP.
Reduce the size of the routing table by setting route summary and disabling the
receiving of host routes.
Filter the received routes.
RIP update
rip input
RIP update rip output
RIP on the
rip work
system-view
interface
interface-number
rip version { 1 | 2 [ broadcast |
multicast ] }
Huawei Technologies Proprietary
Command
Command
interface-type
3-5
Chapter 3 RIP Configuration
Description
Optional
By default, except for
loopback interface, all
interfaces are allowed
to send and receive
RIP packets.
Description
—
—
Optional
By default, the
version on an interface
is RIP-1, and
interface can receive
RIP-1 and RIP-2
broadcast packets but
send only RIP-1
packets. When
specifying the
version on an interface
to RIP-2, you can also
specify the mode
(broadcast or multicast)
to send RIP packets.
RIP
the
RIP