Filtering The Registration Packets From Rp To Dr - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Configure
domain boundary
Caution:
When the PIM-SM domain boundary is set, Bootstrap messages cannot pass the
boundary in any direction. In this way, PIM-SM domains are divided.
When this feature is configured, Bootstrap messages cannot pass the boundary.
However, the other PIM messages can pass the domain boundary. The network can
be effectively divided into domains using different BSRs.

7.4.4 Filtering the Registration Packets from RP to DR

Through the registration packet filtering mechanism in PIM-SM network, you can
determine which sources send packets to which groups on RP, that is, RP can filter the
registration packets from DR and receive the specified packets only.
Table 7-10 Filter the registration packets from RP to DR
Enter system view
Enable
routing protocol
Enter
view
Enable
current interface
Quit VLAN view
Enter PIM view
Operation
PIM-SM
pim bsr-boundary
Operation
system-view
the multicast multicast
routing-enable
VLAN interface interface Vlan-interface
interface-number
IGMP on the
pim sm
quit
pim
Huawei Technologies Proprietary
Command
Command
7-17
Chapter 7 PIM Configuration
Description
Required
By default, domain
boundary is not set for the
switch.
Description
—
Enable the multicast
routing protocol
—
Required
Configure the
protocol type on
interface
—
-
PIM
the