Displaying And Debugging Irf Fabric - Huawei Quidway S3900 Series Operation Manual

Operation Manual – IRF Fabric
Quidway S3900 Series Ethernet Switches-Release 1510
Table 1-10 Set the IRF fabric authentication mode for a switch
Operation
Enter system view
Set the
authentication mode for
the switch
Note:
When an IRF fabric operates normally, you can regard the whole fabric as a single
device and perform configuration on it. Multiple switches constitute an IRF fabric.
Therefore, data transmission and simultaneous program execution among the
switches may cause the IRF fabric in busy condition. When you configure the IRF fabric,
you may receive a prompt "Fabric system is busy, please try later..." which indicates
the fabric system does not execute your configuration properly. In this case, you need
to verify your former configuration or perform your configuration again.

1.4 Displaying and Debugging IRF Fabric

Following completion of the above configuration, you can execute the display
command in any view to view device management and verify the settings. And you can
execute the reset command to clear the FTM statistics.
Table 1-11 Display and debug FTM
Operation
Display the information
about an IRF fabric
Display
information of an IRF
fabric
Display RMON statistics
of a specified unit in an
IRF fabric
Display
data of a specified unit in
an IRF fabric
Clear the FTM statistics
system-view
irf-fabric
IRF fabric
authentication-mode
{ simple password | md5
key }
display irf-fabric [ port |
status ]
the topology
display ftm { information
| topology-database }
display rmon statistics
unit unit-id
RMON history
display
unit unit-id
reset ftm statistics
Huawei Technologies Proprietary
Chapter 1 IRF Fabric Configuration
Command
Command
rmon history
1-10
Description
—
Optional
By default,
authentication mode is set
on a switch.
Description
These commands can be
executed in any view.
Execute this command in
user view
no