Huawei Quidway S3900 Series Operation Manual page 876

Operation Manual – FTP and TFTP
Quidway S3900 Series Ethernet Switches-Release 1510
III. Configuration procedure
1) Start the TFTP server and configure the work directory on the PC.
2) Configure the switch.
# Log into the switch. (You can log into a switch through the Console port or by
Telneting to the switch. See section "Log into an Ethernet Switch" for detailed
information.)
<Quidway>
Caution:
If available space on the Flash memory of the switch is not enough to hold the file to be
uploaded, you need to delete files from the Flash memory to make room for the file.
# Enter system view
<Quidway> system-view
[Quidway]
# Configure the IP address of a VLAN interface on the switch to 1.1.1.1, and ensure that
the port through which the switch connects with the PC belongs to this VLAN. (This
example assumes that the port belongs to VLAN 1.)
[Quidway] interface Vlan-interface 1
[Quidway-vlan-interface1] ip address 1.1.1.1 255.255.255.0
[Quidway-vlan-interface1] quit
# Download the switch application named switch.bin from the TFTP server to the
switch.
<Quidway> tftp 1.1.1.2 get switch.bin switch.bin
# Upload the switch configuration file named vrpcfg.cfg to the TFTP server.
<Quidway> tftp 1.1.1.2 put vrpcfg.cfg vrpcfg.cfg
# Use the boot boot-loader command to specify the downloaded file (switch.bin) to be
the startup file used when the switch starts the next time, and restart the switch. Thus
the switch application is upgraded.
<Quidway> boot boot-loader switch.bin
<Quidway> reboot
Huawei Technologies Proprietary
1-18
Chapter 1 FTP and TFTP Configuration