Ospf Route Control; Configuring Ospf Route Summary - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510

4.6 OSPF Route Control

Perform the following configurations to control the advertisement and reception of the
routing information discovered by OSPF and import routing information discovered by
other protocols.
4.6.1 Configuration Prerequisites
Before configuring OSPF route control, perform the following tasks:
Configuring the network layer addresses of interfaces so that the adjacent nodes
are reachable to each other at the network layer
Completing basic OSPF configuration
Configuring filter list to filter routing information

4.6.2 Configuring OSPF Route Summary

The configuration of OSPF route summary includes:
Configuring ABR route summary,
Configuring ASBR route summary for imported routes.
Table 4-7 Configure ABR route summary
Enter system view
Enter OSPF view
Enter area view
Enable ABR route summary
Table 4-8 Configure ASBR route summary
Enter system view
Enter OSPF view
Operation
Operation
Huawei Technologies Proprietary
Command
system-view
ospf [ process-id
[ router-id router-id ] ]
area area-id
abr-summary
ip-address mask
[ advertise
not-advertise ]
Command
system-view
ospf [ process-id
[ router-id router-id ] ]
4-16
Chapter 4 OSPF Configuration
Description
—
Required
Required
Required
This command takes
effect only when it is
|
configured on an ABR.
By default, this function
is disabled on an ABR.
Description
—
Required