Huawei Quidway S3900 Series Operation Manual page 788

Operation Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510
[Quidway] snmp-agent mib-view include internet 1.3.6.1
[Quidway] snmp-agent group v3 managev3group write-view internet
[Quidway] snmp-agent usm-user v3 managev3user managev3group
# Set the VLAN interface 2 as the interface used by NMS. Add port Ethernet1/0/2 to
VLAN 2. This port will be used for network management. Set the IP address of VLAN
interface 2 as 10.10.10.2.
[Quidway] vlan 2
[Quidway-vlan2] port Ethernet 1/0/2
[Quidway-vlan2] quit
[Quidway] interface Vlan-interface 2
[Quidway-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
[Quidway-Vlan-interface2] quit
# Enable the SNMP agent to send Trap packets to the NMS whose IP address is
10.10.10.1. The SNMP community is public.
[Quidway] snmp-agent trap enable standard authentication
[Quidway] snmp-agent trap enable standard coldstart
[Quidway] snmp-agent trap enable standard linkup
[Quidway] snmp-agent trap enable standard linkdown
[Quidway] snmp-agent target-host trap address udp-domain 10.10.10.1 udp-port
5000 params securityname public
IV. Configuring NMS
The S3900 series switch supports Huawei's QuidView NMS. SNMP V3 adopts user
name and password authentication. In [Quidview Authentication Parameter], you need
to set a user name, choose security level, and set authorization mode, authorization
password, encryption mode, and encryption password respectively according to
different security levels. In addition, you must set timeout time and retry times.
You can query and configure the Ethernet switch through the NMS. For more
information, refer to the manuals of Huawei's NMS products.
Note:
NMS configuration must be consistent with device configuration; otherwise, the NMS
cannot manage the device.
Huawei Technologies Proprietary
1-10
Chapter 1 SNMP Configuration