Huawei Quidway S3900 Series Operation Manual page 683

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510
1.9.1 Configuration Prerequisites
ACL rules used for traffic identifying are defined. Refer to the ACL module in the
book for defining ACL rules
The port that the packets matching with the configurations rules are redirected to
is specified
The ports that needs this configuration are specified
1.9.2 Configuration Procedure
Table 1-13 Configure redirect
Operation
Enter system view
Enter Ethernet port
view
Configure redirect
Display the parameter
configurations
redirect
Display all the QoS
settings of the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules. The
way of combination is described in Table 1-9.
Note:
The redirect configuration is effective only for the ACL rules whose actions are
permit.
When packets are redirected to CPU, they cannot be forwarded normally.
If you set to redirect the traffic to a Combo port which is in down state, the system
automatically redirects the traffic to the up port which is corresponding to the Combo
port.
1.9.3 Configuration Example
Ethernet1/0/1 of the switch is accessed into the 10.1.1.1/24 network segment
Command
system-view
interface interface-type
interface-number
traffic-redirect { inbound |
outbound } acl-rule { cpu |
interface interface-type
interface-number }
display qos-interface
{ interface-type
of
interface-number | unit-id }
traffic-redirect
display qos-interface
{ interface-type
interface-number | unit-id }
all
Huawei Technologies Proprietary
1-21
Chapter 1 QoS Configuration
Description
—
—
Required
Optional
You can execute
display command in any
view
the