Configuring The User Re-Authentication Upon Device Restart Function - Huawei Quidway S3900 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Create
RADIUS
scheme
enter its view
Set
response
timeout time of
RADIUS servers
Set the wait time
for the primary
server to restore
the active state
Set the real-time
accounting
interval
1.4.11 Configuring Whether or not to Send Trap Message When RADIUS Server is
Down
Table 1-22 Configure whether or not to send trap message when RADIUS server is
down
Operation
Enter system view
Enable the sending
of trap
when
authentication
accounting server is
down
Note:
This configuration takes effect on all RADIUS schemes.
A device considers its RADIUS server as being down if it has tried the configured
maximum times to send packets to the RADIUS server but does not receive any
response.

1.4.12 Configuring the User Re-Authentication upon Device Restart Function

Command
a
radius
and radius-scheme-name
the
timer response-timeout
seconds
timer quiet minutes
timer realtime-accounting
minutes
Command
system-view
message radius
RADIUS { authentication-server-do
or wn
accounting-server-down }
Huawei Technologies Proprietary
1-33
Chapter 1 AAA & RADIUS & HWTACACS
Description
Required
scheme
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional
By default, the response timeout
timer of RADIUS servers expires
in three seconds.
Optional
By default, the primary server
waits five
restoring the active state.
Optional
By default,
accounting interval is 12 minutes.
—
Optional
trap
By default, the switch does
|
not send trap message when
its RADIUS server is down.
Configuration
minutes before
the real-time
Description