Huawei Quidway S3900 Series Operation Manual page 308

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
II. Configuring split horizon
Table 3-13 Configure split horizon
Operation
Enter system view
Enter interface view
Enable split horizon
Note:
Split horizon cannot be disabled on a point-to-point link.
III. Configuring RIP-1 packet zero field check
Table 3-14 Configure RIP-1 packet zero field check
Enter system view
Enter RIP view
Enable zero field check of
RIP-1 packets
Note:
Some fields in a RIP-1 packet must be 0, and they are known as zero fields. For RIP-1,
zero field check is performed on incoming packets, those RIP-1 packets with nonzero
value in a zero filed will not be processed further. As a RIP-2 packet has no zero fields,
this configuration is invalid for RIP-2.
IV. Setting RIP-2 packet authentication mode
RIP-2 supports two authentication modes, simple authentication and MD5
authentication.
system-view
interface
interface-number
rip split-horizon
Operation
Huawei Technologies Proprietary
Command
interface-type
Command
system-view
rip
checkzero
3-11
Chapter 3 RIP Configuration
Description
—
—
Optional
By default, an interface
uses split horizon to
send RIP packets.
Description
—
—
Optional
By default, zero field
check is performed on
RIP-1 packets.