Enabling Information Output To The Console - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Define
information source
Set the format of
the time stamp to
be sent to the log
host
Note:
After the switches form a fabric, you can use the info-center switch-on command to
enable the information output for the switch to make the log, debugging and trap
information of each switch in the fabric synchronous. Each switch sends its own
information to other switches in the fabric and receives information sent by other
switches at the same time to update the information on itself. In this way, the switch
ensures the synchronization of log, debugging and trap information in the whole
fabric.
To view the debugging information of specific modules, you need to set the
information type as debug in the info-center source command, and enable
debugging for corresponding modules through the debugging command.

1.2.3 Enabling Information Output to the Console

Table 1-6 lists the related configurations on the switch.
Table 1-6 Enable information output to the console
Operation
Enter system view
Enable
information center
Enable information
output
console
Command
info-center
{ modu-name | default }
an channel { channel-number |
channel-name } [ { log | trap
| debug } * { level severity |
state state } * ]
info-center
loghost
no-year-date | none }
Command
system-view
the
info-center enable
info-center
to the channel { channel-number |
channel-name }
Huawei Technologies Proprietary
source
Required
timestamp
{ date | Optional
—
Optional
By default, the information
center is enabled.
Required
console
By default, the switch uses
information
output
information to the console.
1-8
Chapter 1 Information Center
Description
Description
channel 0
log/debugging/trap
to