Configuring Queue-Scheduling - Huawei Quidway S3900 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510
Redirect all the traffic from the 10.1.1.1/24 network segment to Ethernet1/0/7
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] quit
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] traffic-redirect inbound ip-group 2000 interface
Ethernet1/0/7

1.10 Configuring Queue-scheduling

Refer to 1.1.11 Queue Scheduling for the introduction to queue scheduling.
1.10.1 Configuration Prerequisites
The queue-scheduling algorithm is specified: which queues adopt the WFQ
queue-scheduling algorithm and which queues adopt the SP queue-scheduling
algorithm
1.10.2 Configuration Procedure
Table 1-14 Configure queue scheduling in system view
Operation
Enter system view
Configure the queue
scheduling mode
Display
queue-scheduling
mode
parameters
switch
system-view
queue-scheduler
{ strict-priority
queue0-width queue1-width
queue2-width queue3-width
queue4-width queue5-width
queue6-width queue7-width
| wrr
queue1-weight
queue2-weight
queue3-weight
queue4-weight
queue5-weight
queue6-weight
queue7-weight }
the
and related display queue-scheduler
on the
Huawei Technologies Proprietary
Command
| wfq
queue0-weight
1-22
Chapter 1 QoS Configuration
Description
—
Required
In WRR or WFQ mode, if
the weight value
minimum bandwidth of one
or more queues is set to 0,
SP algorithm is used for
this or these queues
By default, all the outbound
queues on the port adopt
the WRR queue scheduling
algorithm and their default
weight values
1:2:3:4:5:9:13:15
Optional
You can execute
display command in any
view
or
are
the